The short version of GHS-R1a fits in a sentence. The long version — which is the one that helps — is below.
Reviewed 2026-03-13. Anything still debated is marked as such rather than presented as settled.
Ipamorelin is a synthetic pentapeptide classified as a growth hormone secretagogue. Its sequence, Aib-His-D-2-Nal-D-Phe-Lys-NH2, combines three non-proteinogenic residues with a C-terminal amide. The N-terminal aminoisobutyric acid unit and the two aromatic D-amino acids distinguish it from peptides assembled only from standard L-amino acids. Its formula is C38H49N9O5, corresponding to an average mass near 711.9 Da. At neutral pH the molecule carries a net positive charge, a property that shapes its behaviour in chromatographic and electrophoretic systems.
The compound was developed at Novo Nordisk during the 1990s as part of a programme seeking secretagogues with improved selectivity. It was described in the peer-reviewed literature in 1998 alongside related pentapeptides from the same series. Investigators advanced it because it raised growth hormone output in animal models while leaving other pituitary hormones comparatively unaffected. The development code NNC 26-0161 appears in earlier reports, and ipamorelin later became the common designation in published work.
Selectivity is the property most often attached to this peptide. Published animal and early human studies record increases in growth hormone release after administration, with adrenocorticotropic hormone and cortisol responses remaining small by comparison. Effects on appetite-related pathways also appear weaker than those reported for several earlier secretagogues. Reviews that compare members of the growth hormone secretagogue family cite these findings frequently, though the receptor-level explanation for the selectivity continues to be debated rather than settled.
Material supplied for research use is normally a white to off-white lyophilized powder. The solid is hygroscopic and is handled in a low-humidity environment to limit water uptake. Bulk quantities are frequently shipped in sealed vials under inert gas. Once reconstituted in water or a neutral buffer, the solution is less stable than the dry powder and is usually divided into single-use aliquots.
Long-term storage of the dry powder is typically at minus twenty degrees Celsius or lower, protected from light and moisture. Solutions are commonly kept frozen and thawed only once, because repeated freeze-thaw cycles can promote aggregation and loss of measurable peptide content. Buffers near neutral pH are preferred over strongly acidic or strongly basic conditions. Shipping at ambient temperature is acceptable for short periods when the powder remains sealed and desiccated.
Identity and purity are assessed by complementary methods rather than a single test. Reversed-phase high-performance liquid chromatography separates the peptide from related impurities and reports a percentage purity. Mass spectrometry, most often with electrospray ionization, confirms the expected molecular mass and detects sequence-related variants. Amino acid analysis can verify composition, while water content and residual counterion measurements support the mass balance of a batch. Stability studies under accelerated conditions are used to estimate shelf life, though such estimates carry uncertainty for long-term storage.
| Property | Value | Notes |
|---|---|---|
| Molecular formula | C38H49N9O5 | Pentapeptide with C-terminal amide |
| Average mass | Approximately 711.9 Da | Value derived from the formula |
| Appearance | White to off-white powder | Typically supplied as a lyophilised solid |
| Solubility | Soluble in water and aqueous acetonitrile | Dissolution aided by acidic diluents |
| Common synonyms | Ipamorelin; NNC 26-0161 | Code name used in early reports |
Mass spectrometry confirms identity and reveals structural deviations that chromatography alone can miss. Positive-mode electrospray ionisation generally yields multiply charged ions whose deconvoluted mass is checked against the theoretical value. Amino acid analysis, and enzymatic digestion with subsequent fragment mapping, provide independent confirmation of sequence and of the terminal amide. Analysts take care to separate the target from deletion sequences, which may differ by one residue and therefore by only a small mass increment.
The lyophilised solid is normally held at -20 °C or colder, shielded from light and moisture. Stability in that state is measured in years, although shelf life depends on residual water content and the container seal. Once dissolved, the peptide is more fragile: aqueous solutions are commonly kept at 2-8 °C and used within days to weeks, and repeated freeze-thaw cycling is avoided. Strongly acidic or basic conditions accelerate hydrolysis, and prolonged exposure to them can strip the terminal amide.
Compared with earlier growth hormone secretagogues such as GHRP-6 and hexarelin, ipamorelin has been reported to produce less stimulation of adrenocorticotropic hormone, cortisol, and prolactin in animal and early human studies. This selectivity is usually attributed to differences in receptor subtype interactions and to the tissue distribution of the receptor. Effects on appetite appear weaker than those of ghrelin itself, although the supporting evidence base is small. Whether these differences produce a distinct clinical profile remains an open question, since controlled human trials are limited.
Ipamorelin is a synthetic pentapeptide first described in the 1990s by researchers at Novo Nordisk during a program to develop selective growth hormone secretagogues. Its sequence is Aib-His-D-2-Nal-D-Phe-Lys-NH2, incorporating two non-natural residues, alpha-aminoisobutyric acid and D-2-naphthylalanine. The C-terminus is amidated, and the material is supplied as a white lyophilized powder. The molecular formula is C38H49N9O5 and the monoisotopic mass is approximately 711.85 daltons. The short chain and modified residues give it greater resistance to enzymatic degradation than many larger peptide hormones.
At the molecular level, ipamorelin acts as an agonist at the growth hormone secretagogue receptor type 1a, the same G protein-coupled receptor that binds ghrelin. Receptor activation couples to Gq/11 signaling, raising intracellular calcium through inositol trisphosphate and diacylglycerol, which in turn promotes exocytosis of growth hormone from pituitary somatotroph cells. Ipamorelin binds this receptor with high affinity and shows weak activity at other secretagogue-related targets in vitro. Its action requires the intact receptor and is not reversed by growth hormone-releasing hormone antagonists.
2,4,6-Triisopropylbenzenesulfonyl azide (trisyl azide) is an organic chemical used as a reagent to supply azide for electrophilic amination reactions, such as for the asymmetric synthesis of unnatural amino acids. Introduction of an azide on the α carbon of carboxylic acid derivatives using trisyl azide is an efficient alternative to electrophilic halogenation followed by nucleophilic substitution using anionic azide. Using an oxazolidinone as chiral auxiliary typically gives good induction of the stereochemistry at the α position. Subsequent reduction converts the α-azide to an α-amine.
5-Hydroxyeicosanoid dehydrogenase (5-HEDH) or more formally, nicotinamide adenine dinucleotide phosphate (NADP+)-dependent dehydrogenase, is an enzyme that metabolizes between two eicosanoid metabolites of arachidonate 5-lipoxygenase (5-LOX): 5-hydroxyeicosatetraenoic acid (5-(S)-HETE), and its 5-keto analog 5-oxo-eicosatetraenoic acid (5-oxo-ETE). It also acts in the reverse direction, metabolizing 5-oxo-ETE to 5(S)-HETE. Since 5-oxo-ETE is 30–100-fold more potent than 5(S)-HETE in stimulating various cell types, 5-HEDH is regarded as a regulator and promoter of the influence that 5-LOX and its metabolites have on cell function. Although 5-HEDH has been evaluated in a wide range of intact cells and in crude microsome preparations, it has not yet been evaluated for its structure or gene, and most studies on it have been limited to human tissues.
Studies indicate that a substantial part of the modern vehicle's value comes from intelligent systems, and that these represent most of the current automotive innovation. To facilitate this, the modern automotive engineering process has to handle an increased use of mechatronics. Configuration and performance optimization, system integration, control, component, subsystem and system-level validation of the intelligent systems must become an intrinsic part of the standard vehicle engineering process, just as this is the case for the structural, vibro-acoustic and kinematic design. This requires a vehicle development process that is typically highly simulation-driven.
Sources: en.wikipedia.org
The structures of human P-TEFb containing Cdk9 and cyclin T1 and the HIV Tat•P-TEFb complex have been solved using X-ray crystallography. The first structure solved demonstrated that the two subunits were arranged as has been found in other cyclin dependent kinases. Three amino acid substitutions were inadvertently introduced in the subunits used for the original structure and a subsequent structure determination using the correct sequences demonstrated the same overall structure except for a few significant changes around the active site. The structure of HIV Tat bound to P-TEFb demonstrated that the viral protein forms extensive contacts with the cyclin T1 subunit (Figure 2).
Acta Biochimica et Biophysica Sinica was a Chinese-language journal entitled "Shengwu Huaxue Yu Shengwu Wuli Xuebao" (see box below), which began publishing sometime in 1958 or 1959, or August 1961, until December 2003 (depending on the source). Tables of contents were in English. Summaries (abstracts) were in English and Russian, and text of articles in Chinese. Later issues were promulgated in the Chinese and English languages. The translated title was "Journal of Biochemistry and Biophysics". The frequency was quarterly from 1959 to 1963, bimonthly from 1964 to 2002, and finally, monthly by 2003. Publication was suspended from 1966 to 1975. It was indexed in Chemical Abstracts Service. It may have published 35 volumes in total, over the years. In 2004 the journal switched to a full English-language journal under its current title. Official website Institute of Biochemistry and Cell Biology Archived 2003-12-17 at the Wayback Machine, SIBS, CAS
The standard botanical author abbreviation Tswett is applied to plants that he described. Ostrowski, W (1968). "Michael S. Tswett—inventor of column chromatography (On the occasion of 65th anniversary of his lecture on the column chromatography technique)". Folia Biol. (Krakow). Vol. 16, no. 4. pp. 429–48. PMID 4885242. R. Willstätter, A. Stoll, Untersuchungen über Chlorophyll, Springer, Berlin (1913) Biography of Mikhail S. Tsvet (pdf, in German) Mikhail S. Tsvet: Physical chemical studies on chlorophyll adsorptions Berichte der Deutschen botanischen Gesellschaft 24, 316–323 (1906)
As part of the Synthetic Yeast 2.0 project, various research groups around the world have participated in a project to synthesise synthetic yeast genomes, and through this process, optimise the genome of the model organism Saccharomyces cerevisiae. The Yeast 2.0 project applied various DNA assembly methods that have been discussed above, and in March 2014, Jef Boeke of the Langone Medical Centre at New York University, revealed that his team had synthesized chromosome III of S. cerevisiae. The procedure involved replacing the genes in the original chromosome with synthetic versions and the finished synthetic chromosome was then integrated into a yeast cell. It required designing and creating 273,871 base pairs of DNA – fewer than the 316,667 pairs in the original chromosome. In March 2017, the synthesis of 6 of the 16 chromosomes had been completed, with synthesis of the others still ongoing.
Sources: en.wikipedia.org
It is a synthetic five-amino-acid peptide that acts as a growth hormone secretagogue. Three of its residues are non-standard amino acids, and the chain ends in an amide rather than a free acid. The molecule is small enough that it can be characterised by routine peptide analytical techniques.
It has not received marketing approval as a medicine in the United States or the European Union. Supplied material is generally described and handled as a research chemical. Regulatory treatment varies by jurisdiction, and some countries restrict growth hormone secretagogues under sports or medicines legislation.
Earlier secretagogues were associated with broader hormonal responses, including measurable changes in cortisol and prolactin. Reports on this peptide describe a narrower profile in which growth hormone release is the most prominent effect. The observation is influential because it shapes how the compound is compared with other members of the same receptor family.
Dry powder is held at minus twenty degrees Celsius or colder, away from light and moisture. Sealed vials under inert gas limit degradation during storage.